Seagull Models Ultimate Specifikace

Kit features.• Ready-made—minimal assembly & finishing required.• Ready-covered covering.• Photo-illustrated step-by-step Assembly Manual.Made in

ULTIMATE. Instruction Manual.10 Attach the silicone fuel and pressure pipesto

www.seagullmodels.com11(2) Wheel Collar.Axle.Wheel.Nut.Nut.(2) Washer.Landing gear. 3) You have to trim each axle using a toolcutting and cut-off w

ULTIMATE. Instruction Manual.12Pushrod wire.4x30mm. 4) Remove the engine. Us

www.seagullmodels.com13 3) Install the muffler and muffler extensiononto the engine and make the cutout in thecowl for muffler clearance. Connect th

ULTIMATE. Instruction Manual.14Remove covering. 3) Secure the servos with the s

www.seagullmodels.com15 7) When you are sure that everything isaligned correctly, mix up a generous amountof 30 Minute Epoxy. Apply a thin layer to

ULTIMATE. Instruction Manual.16 5) Slide the vertical stabilizer back inplace.

www.seagullmodels.com17Control Horn.Mounting Screws.Mounting Plate. 4) Install the rudder control horn using thesame method as with the elevator cont

ULTIMATE. Instruction Manual.18MOUNTING THE CONTROL CLASP. See pictures below:

www.seagullmodels.com19THE CENTER RIB INSTALLATION.B(2) 3x10cm.Rib centerCB See pictures below:ATTACHMENT WING.(D) Lower wing tube:36.3cm.(E) Upper

ULTIMATE. Instruction Manual.2INTRODUCTION. Thank you for choosing the ULTIMAT

ULTIMATE. Instruction Manual.20 Place on strut into position. Make sure thecur

www.seagullmodels.com21INSTALLING THE CANOPY HATCH.4 1) It is critical that your airplane be bal-anced correctly. Improper balance will causeyou

ULTIMATE. Instruction Manual.22FLIGHT PREPARATION.  A) Check the operation

www.seagullmodels.com23If you as the Purchaser or user are not prepared to accept the liability associated with the use of this Product, you areadvise

ULTIMATE. Instruction Manual.24Warranty Inspection and RepairsTo receive warrant

www.seagullmodels.com3NOTE: To avoid scratching your new aero-plane we suggest that you cover yourworkbench with an old towel. Keep acouple of jars or

ULTIMATE. Instruction Manual.4Work the aileron up and down severaltimes to “work

www.seagullmodels.com5String.Small weight.Because the size of servos differ, youmay need to adjust the size of the precut open-ing in the mount. The

ULTIMATE. Instruction Manual.6 1) Using a ruler & pen to draw a straightlin

www.seagullmodels.com7M2 lock nut.Mark point.Cut.3x30mm. Repeat the procedure for the otheraileron servo. Installing the turnbuckle for ailer

ULTIMATE. Instruction Manual.8PLASTIC STRAP INSTALLATIONLOWER WING. Installing

www.seagullmodels.com9INSTALLING THE BATTERY 1) Using a modeling knife, carefully cutoff the rear portion of one of the 3 nylon tubesleaving 1/2” pr